Generate QR code
Open Access
Subscription Access
Influence of Ion-plasma treatment of reinforcing fillers on the complex of PCM properties
https://doi.org/10.22349/1994-6716-2022-109-1-134-146
Abstract
This paper presents the results of studying samples of glass-carbon plastics based on reinforcing fillers subjected to ion-plasma treatment. The influence of the speed of surface treatment on the complex of physical and mechanical characteristics of glass-fiber-reinforced plastics is shown. According to the results of microstructural studies, it was found that ion-plasma treatment promotes an increase in interfacial interaction at the fiber-matrix interface. The effect of ion-plasma treatment of reinforcing fillers on the properties of PCM samples in a moisture-saturated state is shown.
Keywords
ion-plasma treatment,
ion-plasma treatment in vacuum,
atmospheric ion-plasma treatment,
fiberglass,
strength characteristics,
moisture absorption
Supporting agencies: The authors are grateful to S.L. Lonsky, Engineer of the Laboratory for Polymeric Binders, Adhesives and Special Liquids, for conducting microstructural studies.
About the Authors
E. D. Kolpachkov
НИЦ «Курчатовский институт» – ВИАМ
Russian Federation
Russian Federation
P. A. Shchur
ФГАОУ ВО «Московский авиационный институт (Национальный исследовательский университет»)
Russian Federation
Russian Federation
E. V. Kurshev
НИЦ «Курчатовский институт» – ВИАМ
Russian Federation
Russian Federation
I. Yu. Chernyaeva
ФГАОУ ВО «Московский авиационный институт (Национальный исследовательский университет»)
Russian Federation
Russian Federation
A. V. Shvedov
ФГАОУ ВО «Московский авиационный институт (Национальный исследовательский университет»)
Russian Federation
Russian Federation
References
1. Kablov, E.N., Startsev, O.V., Panin, S.V., Vlagoperenos v ugleplastike s destruktirovannoy poverkhnostiyu [Moisture transfer in CFRP with a destructed surface], Reports of the Academy of Sciences, 2015, V. 461, No 4, pp. 433–436.
2. Kablov, E.N., Valueva, M.I., Zelenina, I.V., Khmelnitsky, V.V., Aleksashin, V.M., Ugleplastiki na osnove benzoksazinovykh oligomerov – perspektivnye materialy [Carbon plastics based on benzoxazine oligomers, promising materials], Trudy VIAM, 2020, No 1 (85), pp. 68–77. URL: http://www.viam-works.ru (reference date: 22/11/2021). DOI: 10.18577/2307/-6046-2020-0-1-68-77.
3. Kablov, E.N., Rol fundamentalnykh issledovaniy pri sozdanii materialov novogo pokoleniya Mendeleevskogo siezda po obshchey i prikladnoy khimii [The role of fundamental research in the creation of new generation materials], Proceedings of 21st Mendeleev Congress on General and Applied Chemistry, St Petersburg, 2019, V. 4, p. 24.
4. Kolpachkov, E.D., Marakhovsky, P.S., Petrova, A.P., Shchur, P.A., Lonsky, S.L. , Chernyaeva, I.Yu., Shvedov, A.V., Issledovanie vliyaniya ionno-plazmennoy obrabotki na svoystva poverkhnosti armiruyushchikh napolniteley [Investigation of the effect of ion-plasma treatment on the properties of the surface of reinforcing fillers], Voprosy Materialovedeniya, 2021, No 3 (107), pp. 136–149.
5. Tikhomirov, A.S., Sorokina, N.E., Avdeev, V.V., Modifitsirovanie poverkhnosti uglerodnogo volokna rastvorami azotnoy kisloty [Surface modification of carbon fiber with nitric acid solutions], Neorganicheskie materialy, 2011, V. 47, No 6, pp. 684–688.
6. Li, J., Sun, F.F., The effect of nitric acid oxidization treatment on the interface of carbon fiberreinforced thermoplastic polystyrene composite, Polym.-Plast. Technol. and Eng., 2009, V. 48. No 7, pp. 711–715.
7. Vazquez-Santos, M.B., Suarez-Garcia, F., Activated Carbon fibers with a high heteroatom content by chemical activation of PBO with phosphoric acid, Langmuir, 2012, No 13, pp. 5850–5860.
8. Fu, R., Liu, L., Huang, W., Studies on the structure of activated carbon fibers activated by phosphoric acid, J. Appl. Polym. Sci., 2003, V. 87, pp. 2253–2261.
9. Pradhan, B.K., Sandle N.K., Effect of different oxidizing agent treatments on the surface properties of activated carbons, Carbon, 1999, V. 37, pp. 1323–1332.
10. Suarez-Garcia, F., Castro-Muniz, A., Tascon, J.M.D., Activated carbon fibers with a high content of surface functional groups by phosphoric acid activation of PPTA, Journal of Colloid and Interface Science, 2011, V. 361, pp. 307–315.
Review
For citations:
Kolpachkov E.D., Shchur P.A., Kurshev E.V., Chernyaeva I.Yu., Shvedov A.V. Influence of Ion-plasma treatment of reinforcing fillers on the complex of PCM properties. Voprosy Materialovedeniya. 2022;(1(109)):134-146. (In Russ.) https://doi.org/10.22349/1994-6716-2022-109-1-134-146
Views:
164
Email this article 